2. Open the drive release latch by pressing the latch release button. The release latch should spring partially
open. See Removing a Drive on page 30 for an illustration of the release button location.
3. Lift the drive release latch to its fully open position before inserting the drive into the slot. See Removing a
Drive on page 30 for an illustration of the release latch movement.
4. Hold the drive by its carrier and insert the drive into an empty slot as shown in Figure 21.
Figure 21: Iinstalling a Drive - Placing in Array Slot
5. Push the drive into the slot. The drive handle will begin to close onto the drive as it is inserted.
6. When the drive is fully inserted as far as it can go, rotate the drive release latch to its fully closed position.
Push down on the latch until you hear and feel a click. See Figure 22.
33
Dell EqualLogic PS-M4110 Hardware Owner's Manual Installing a Drive
To Next Page
Loading...
