Dell Force10 C150 - Page 48

48 | System Boot
www.dell.com | support.dell.com
Refer to the FTOS Command Line Interface Reference for BOOT_USER mode commands and
commands for run-time modes.
interface management port
config 100m
interface management port
config 10m
interface management port
config auto-negotiate
interface management port
config no auto-negotiate
interface management port
config full-duplex
interface management port
config half-duplex
interface management port
config show
• Use these commands to set the speed and duplex settings for the Management
interface.The default setting is full-duplex and auto-negotiation.
• Use the interface management port config show command to
view the Management interface’s physical settings.
show interface management
ethernet
interface management ethernet
ip address
ip-address ip-address-
mask
• Use the show interface management ethernet command to
display the IP address and network mask of the management Ethernet port.
• If the show command output does not display configured IP address
information, use the interface management ethernet ip
address ip-address ip-address-mask command to set the IP address of
the Management Ethernet port for network (ftp/tftp) operating system boot.
Use CIDR block notation for the subnet mask.
boot zero {default | primary
| secondary}
Delete the boot configuration.
reload Reload software.
The autoboot program initializes and displays self-test results on the console
screen.
NOTE: Do not press break control sequence at any time during the boot/
reboot process. Doing so causes the boot process to terminate.
Command Purpose (continued)
BOOT_USER # show interface management ethernet
No IP address set for interface management ethernet 0/0!
BOOT_USER # interface management ethernet ip address 1.2.3.4/24
Management ethernet 0/0 IP address: 1.2.3.4/24