Replacing the status-light board
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Align the screw holes on the status-light board with the screw holes on the computer base.
2 Replace the screw (M2x3) that secures the status-light board to the computer base.
3 Slide the status-light board cable into the connector on the status-light board and close the latch to secure the cable.
Post-requisites
1 Follow the procedure from step 7 to step 23 in Replacing the computer base.
2 Replace the rear cover.
3 Replace the battery.
4 Replace the base cover.
22
44 Replacing the status-light board
To Next Page
Loading...
