Identifier GUID-98068FC2-1C1C-46DE-B3FA-DF9D488E9BA1
Status Released
Removing the base cover
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Identifier GUID-201A582F-4C93-4AEB-87A8-BBDF38BCD09D
Status Released
Procedure
1 Loosen the two captive screws on the base cover.
2 Remove the seven screws (M2x7) that secure the base cover to the palm-rest assembly.
NOTE
: The two captive screws when released will create a gap which can be used to pry and lift the base cover o the
palm-rest assembly.
6
16 Removing the base cover
To Next Page
Loading...
