Identifier GUID-3B11745F-7767-4F34-952B-9BF26C45D43E
Status Released
Removing the hard drive
If your computer is using a SATA storage device accelerated by Intel Optane memory, disable Intel Optane before removing the SATA
storage device. For more information about disabling the Intel Optane, see Disabling Intel Optane.
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
CAUTION: Hard drives are fragile. Exercise care when handling the hard drive.
CAUTION: To avoid data loss, do not remove the hard drive while the computer is in sleep or on state.
Identifier GUID-6F56B68C-6A4D-4FC7-8AB8-8AB91F615D26
Status Released
Prerequisites
1 Remove the base cover.
2 Remove the battery.
Identifier GUID-E15D7D5B-FE25-4E17-9B69-1A6B27B8FDA0
Status Released
Procedure (Applicable only on computers shipped
with 4-cell battery)
1 Open the latch and disconnect the hard-drive cable from the system board.
2 Remove the three screws (M2x4) that secure the hard-drive assembly to the palm-rest assembly.
3 Lift the hard-drive assembly, along with its cable, o the palm-rest assembly.
12
Removing the hard drive 33
To Next Page
Loading...
