3 Connect the I/O-board cable to the connector on the system board and close the latch to secure the cable.
4 Connect the coin-cell battery cable to the system board.
5 Connect the ngerprint-reader cable to the connector on the system board and close the latch to secure the cable.
6 Connect the hard-drive cable and to the connector on the system board and close the latch to secure the cable (optional).
7 Connect the touchpad cable to the connector on the system board and close the latch to secure the cable.
8 Connect the keyboard back-light cable to the connector on the system board and close the latch to secure the cable.
9 Connect the keyboard cable to the connector on the system board and close the latch to secure the cable.
10 Connect the speaker cable to the system board.
11 Align the screw holes on the USB Type-C port bracket with the screw holes on the system board.
12 Replace the two screws (M2x4) that secure the USB Type-C port bracket to the system board.
13 Align the display-assembly cable with the screw hole on the system board.
14 Replace the screw (M2x4) that secures the display-assembly cable to the system board.
15 Connect the display cable to the connector on the system board and close the latch to secure the cable.
16 Adhere the tape that secures the display cable to the system board.
17 Connect the power-adapter port cable to the system board.
96
Replacing the system board
To Next Page
Loading...
