Figure 52. Palm-rest and keyboard assembly
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the tasks in the Post-requisites to install the
palm-rest and keyboard assembly.
NOTE:
The palm-rest and keyboard assembly consists of the following:
● Palm rest
● Keyboard
Next steps
1. Install the touchpad.
2. Install the power button.
3. Install the I/O-board and USB-board cable.
4. Install the USB board.
5. Install the I/O board.
6. Install the system board.
NOTE: The system board can be installed with the heat sink pre-attached.
7. Install the power-adapter port.
8. Install the speaker and antenna assembly.
9. Install the wireless card.
10. Install the fan.
11. Install the display assembly.
12. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever is applicable.
13. Install the battery.
14. Install the base cover.
15. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
87
To Next Page
Loading...
