Dell Inspiron 3030 - Page 76

Figure 48. Installing the system board
3. Replace the eight screws (6-32) that secure the system board to the chassis.
4. Route and connect all the cables that you disconnected from the system board.
● processor-power cable
● system-board power cable
● optical-drive data cable
● optical-drive power cable
5. Place and align the front I/O-bracket with the I/O slot on the chassis.
6. Replace the two screws (6-32) that secure the front I/O-bracket to the chassis.
Next steps
1. Install the processor.
2. Install the processor fan and heat-sink assembly.
3. Install the fan shroud.
4. Install the media-card reader.
5. Install the coin-cell battery.
6. Install the wireless card.
7. Install the graphics card.
76
Removing and installing Field Replaceable Units (FRUs)