Steps
1. Connect the battery cable to the system board, if applicable.
2. Place the base cover on top of the palm-rest and keyboard assembly.
3. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the
base cover into place.
4. Tighten the two captive (M2x7) screws that secure the base cover to the palm-rest and keyboard assembly.
5. Replace the five (M2x4) screws that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in After working inside your computer.
Battery
Removing the 3-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: The following procedure applies only to computers shipped with a 3-cell battery.
The following images indicate the location of the 3-cell battery and provide a visual representation of the removal procedure.
16
Removing and installing components
To Next Page
Loading...
