4. Install the 2230 solid-state drive or the 2280 solid-state drive in M.2 slot two. (if applicable)
5. Install the memory modules.
6. Install the 3-cell battery or 4-cell battery, whichever applicable.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or the 4-cell battery, whichever applicable.
4. Remove the 2230 solid-state drive or the 2280 solid-state drive from M.2 slot one.
5. Remove the 2230 solid-state drive or the 2280 solid-state drive from M.2 slot two. (if applicable)
6. Remove the wireless card.
7. Remove the fan.
8. Remove the coin-cell battery.
9. Remove the display assembly.
10. Remove the power-adapter port.
11. Remove the speakers (3-cell battery configuration) or speakers (4-cell battery configuration), whichever applicable.
12. Remove the power-button with optional fingerprint reader.
13. Remove the touchpad.
14. Remove the I/O board.
15. Remove the system board.
NOTE: The system board can be removed along with the heat sink and memory.
About this task
After performing the steps in the pre-requisites, we are left with the palm-rest and keyboard assembly.
60
Removing and installing components
To Next Page
Loading...
