NOTE: Before installing your 2230 or 2280 solid-state drive, ensure that the mounting bracket is in the correct location. For
more information, see Installing the solid-state drive mounting bracket.
NOTE: If there is only one solid-state drive in the configuration you ordered, you may install another solid-state drive in the
other M.2 slot. However, you need a solid-state drive bracket (sold separately) to install the additional solid-state drive.
The following image indicates the location of the 2230 solid-state drive that is installed in M.2 slot one and provides a visual
representation of the installation procedure.
Steps
1. Align the notch on the 2230 solid-state drive with the tab on M.2 slot one on the system board.
2. Slide the 2230 solid-state drive into M.2 slot one on the system board.
3. Replace the screw (M2x3) that secures the 2230 solid-state drive to the solid-state drive mounting bracket.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the 2280 solid-state drive from M.2 slot one
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE:
Depending on the configuration ordered, your computer may support a 2230 solid-state drive, or a 2280 solid-state
drive in M.2 slot one.
NOTE: This procedure applies only to computers shipped with a 2280 solid-state drive installed in M.2 slot one.
The following image indicates the location of the 2280 solid-state drive that is installed in M.2 slot one and provides a visual
representation of the removal procedure.
Removing and installing components
23
To Next Page
Loading...
