Steps
1. Using the alignment posts, place the I/O board on the palm-rest and keyboard assembly.
2. Replace the (M2x3) screw that secures the I/O board to the palm-rest and keyboard assembly.
3. Connect the coin-cell battery cable to the I/O board.
4. Connect the power-button board cable to the I/O board and close the latch.
5. Connect the I/O-board cable to the I/O board and close the latch.
6. Adhere the tape that secures the I/O-board cable latch to the I/O board.
Next steps
1. Install the display assembly.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or the 4-cell battery, whichever applicable.
4. Remove the memory modules.
5. Remove the 2230 solid-state drive or the 2280 solid-state drive from M.2 slot one.
6. Remove the 2230 solid-state drive or the 2280 solid-state drive from M.2 slot two. (if applicable)
7. Remove the wireless card.
8. Remove the heat sink.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
56
Removing and installing components
To Next Page
Loading...
