Steps
1. Place the display assembly on a clean and flat surface with the display panel facing up.
2. Place the palm-rest and keyboard assembly under the display hinges.
NOTE: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
3. Close the display hinges and align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard
assembly.
4. Replace the four screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
5. Route the display cable through the routing guide on the palm-rest and keyboard assembly.
6. Connect the display cable to the connector on the system board and close the latch.
7. Adhere the tape that secures the display-cable connector latch to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
Steps
1. Remove the two (M2.5x5) screws that secure the right display-hinge to the system board.
2. Pry open the right display-hinge.
44
Removing and installing components
To Next Page
Loading...
