Steps
1. Lift the Mylar to uncover the memory module.
2. Use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot until the memory
module pops-up.
3. Remove the memory module from the memory-module slot.
NOTE: Repeat steps 1 to 3 to remove any other memory modules installed in your computer.
Installing the memory modules
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: Your computer can support up to two memory modules.
The following image indicates the location of the memory module and provides a visual representation of the installation
procedure.
20
Removing and installing components
To Next Page
Loading...
