Steps
1. Peel the tape that secures the display cable to the system board.
2. Open the latch, and then disconnect the display cable from the connector on the system board.
3. Remove the display cable from the routing guide on the palm-rest and keyboard assembly.
4. Remove the four screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
5. Pry open the left and right display hinges.
6. Lift the palm-rest and keyboard assembly off the display assembly.
NOTE: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
7. After performing the above steps, you are left with the display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
42
Removing and installing components
To Next Page
Loading...
