Steps
1. Remove the screw (M2x3) that secures the 2280 solid-state drive to the palm-rest and keyboard assembly.
2. Slide and lift the 2280 solid-state drive off M.2 slot one on the system board.
Installing the 2280 solid-state drive in M.2 slot one
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
Depending on the configuration ordered, The computer one may support a 2230 solid-state drive, or a 2280
solid-state drive in M.2 slot one.
NOTE: This procedure is applicable if you are installing a 2280 solid-state drive in M.2 slot one.
NOTE: Before installing your 2230 or 2280 solid-state drive, ensure that the mounting bracket is in the correct location. For
more information, see Installing the solid-state drive mounting bracket.
NOTE: If there is only one solid-state drive in the configuration you ordered, you may install another solid-state drive in the
other M.2 slot. However, you need a solid-state drive bracket (sold separately) to install the additional solid-state drive.
The following image indicates the location of the 2280 solid-state drive that is installed in M.2 slot one and provides a visual
representation of the installation procedure.
24
Removing and installing components
To Next Page
Loading...
