The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
NOTE:
If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the system board.
4. Adhere the tapes that secure the speaker cable to the system board and palm-rest and keyboard assembly.
5. Connect the keyboard-backlight cable and keyboard cable to the system board.
Next steps
1. Install the solid-state drive in M.2 slot two. (if applicable)
2. Install the 4-cell battery.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
50
Removing and installing components
To Next Page
Loading...
