About this task
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
Steps
1. Place the touchpad into the slot on the palm-rest and keyboard assembly.
NOTE: Turn the computer over and open the display. Ensure that the touchpad is equally aligned along all four sides.
2. Replace the two (M2x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the touchpad to the palm-rest and keyboard assembly.
4. Place the touchpad bracket on the touchpad.
5. Align the screw holes on the touchpad bracket with the screw holes on the palm-rest and keyboard assembly.
6. Replace the three (M1.6x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
7. Connect the touchpad cable to the system board and close the latch.
Next steps
1. Install the 3-cell battery or 4-cell battery, whichever applicable.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
54
Removing and installing components
To Next Page
Loading...
