The following images indicate the location of the SSD and provide a visual representation of the removal procedure.
Steps
1. Remove the single screw (M2x3) that secures the SSD thermal plate and remove the thermal plate from the SSD.
2. Slide and remove the SSD from the M.2 card slot on the system board.
Installing the solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: The following steps are for the systems that are shipped with an M.2 solid-state drive (SSD).
The following image indicates the location of the SSD and provides a visual representation of the installation procedure.
18
Removing and installing components
To Next Page
Loading...
