Steps
1. Align and place the touch-panel assembly on the display cover.
2. Connect the display cable to the connector on the touch control board.
3. Affix the tape to secure the connector on the touch control board.
4. Connect the display cable to the connector on the display panel.
5. Affix the rubber sticker on the display cable connector.
6. Affix the mylar tape to secure the display cable on the rear of the display panel.
7. Gently snap the touch panel assembly into place.
Next steps
1. Install the display assembly.
2. Install the palmrest and keyboard assembly.
3. Follow the procedure in after working inside your computer.
Display bezel
Removing the display bezel
Prerequisites
NOTE: The following steps are for Latitude 3120 systems.
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
3. Remove the display assembly.
About this task
The following images indicate the location of the display bezel and provide a visual representation of the removal procedure.
Removing and installing components
49
To Next Page
Loading...
