Dell Latitude 3120 - Installing the Coin-Cell Battery

About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
Steps
1. Disconnect the coin cell battery cable from the connector on the system board.
2. Pry the coin cell battery to release it from the adhesive. Lift and remove it from the computer chassis.
Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the coin-cell battery and provides a visual representation of the installation
procedure.
22
Removing and installing components