Steps
1. Place the power-adapter port into the slot on the computer chassis.
2. Replace the two screws (M2x4) that secure the power-adapter port to the computer chassis.
3. Connect the power-adapter port cable to the connector on the system board.
Next steps
1. Install the palmrest and keyboard assembly.
2. Follow the procedure in after working inside your computer.
World-facing camera
Removing the world-facing camera
Prerequisites
NOTE: The following world-facing camera removal procedure is applicable for Latitude 3120 2-in-1 only.
CAUTION: This is a fragile component. Handle with care.
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
About this task
The following images indicate the location of the world-facing camera and provide a visual representation of the removal
procedure.
Removing and installing components
35
To Next Page
Loading...
