Steps
1. Align and replace the 4-cell battery into the computer chassis.
2. Route the battery cable through the routing channels between the system board and 4-cell battery.
3. Affix the adhesive tapes to secure the 4-cell battery to the computer chassis.
4. Replace the five screws (M2x3) to secure the 4-cell battery in place.
5. Connect the battery cable to the system board.
Next steps
1. Install the palmrest and keyboard assembly.
2. Follow the procedure in after working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Removing and installing components
29
To Next Page
Loading...
