Steps
1. Insert the world-facing camera module into the slot on the computer chassis.
2. Replace the single screw (M2.5x2.5) to secure the front-facing camera module to the computer chassis.
3. Connect the world-facing camera cable to the connector on the camera module.
Next steps
1. Install the palmrest and keyboard assembly.
2. Follow the procedure in after working inside your computer.
Heatsink assembly
Removing the heatsink assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
About this task
The following images indicate the location of the heatsink assembly and provide a visual representation of the removal
procedure.
Removing and installing components
37
To Next Page
Loading...
