Steps
1. Disconnect the world-facing camera cable from the connector on the camera module.
2. Remove the single screw (M2.5x2.5) that secures the front-facing camera module to the computer chassis.
3. Remove the world-facing camera module from the computer chassis.
4. Lift and remove the world-facing camera module from the computer chassis.
Installing the world-facing camera
Prerequisites
NOTE: The following world-facing camera installing procedure is applicable for Latitude 3120 2-in-1 only.
CAUTION: This is a fragile component. Handle with care.
About this task
The following image indicates the location of the front-facing camera and provides a visual representation of the installation
procedure.
36
Removing and installing components
To Next Page
Loading...
