Steps
1. Connect the display cable on the connector on the display panel.
2. Affix the rubber sticker on the display cable connector.
3. Affix the mylar tape to secure the display cable on the rear of the display panel.
4. Align the display panel with the display assembly. Gently snap the display bezel into place.
5. Replace the four screws (M2x2.5) to secure the display panel on the display assembly.
6. Gently flip over the display panel.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the palmrest and keyboard assembly.
4. Follow the procedure in after working inside your computer.
Front facing camera
Removing the front facing camera
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
56
Removing and installing components
To Next Page
Loading...
