About this task
The following image indicates the location of the display hinge and provides a visual representation of the installation procedure.
Steps
1. Align and place the display hinges on the display assembly.
2. For Latitude 3120, replace the two (M2x2.5) screws and four (M2.5x2.5) screws to secure the display hinges to the display
assembly.
3. For Latitude 3120 2-in-1, replace the six (M2.5x2.5) screws and four (M2x2) screws to secure the display hinges to the
display assembly.
4. Affix the tape from the left hinge to secure the display cable.
5. Affix the tape from the right hinge to secure the WLAN antenna cables.
Next steps
1. Install the palmrest and keyboard assembly.
2. Install the display assembly.
3. Install the display bezel.
4. Install the display panel.
5. Follow the procedure in after working inside your computer.
62
Removing and installing components
To Next Page
Loading...
