Steps
1. Align and place the power button with fingerprint reader on the palm-rest and keyboard assembly.
2. Replace the single screw (M2x2.5) to secure the power button with optional fingerprint reader to the palm-rest and
keyboard assembly.
Next steps
1. Install the system board.
2. Install the heat sink.
3. Install the fan.
4. Install the battery.
5. Install the WWAN card (optional).
6. Install the WLAN card.
7. Install the base cover.
8. Follow the procedure in after working inside your computer.
Display assembly
Removing the display assembly (laptop)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the WLAN card.
4. Remove the WWAN card (optional).
5. Remove the battery.
48
Removing and installing components
To Next Page
Loading...
