8. Route the antenna cables underneath the fan.
9. Connect the eDP cable on to its connector on the system board and adhere the conductive tape.
10. Connect the display cable to its connector on the system board.
11. Replace the single screw (M2x4) to secure the display cable bracket.
Next steps
1. Install the battery.
2. Install the WWAN card (optional).
3. Install the WLAN card.
4. Install the base cover.
5. Follow the procedure in after working inside your computer.
Removing the display assembly (2-in-1)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the WLAN card.
4. Remove the WWAN card (optional).
5. Remove the battery.
About this task
The following images indicate the location of the display assembly for 2-in-1 and provide a visual representation of the removal
procedure.
Removing and installing components
53
To Next Page
Loading...
