Steps
1. Peel off the tape securing the eDP cable to the back cover.
2. Remove the eDP cable from the system.
Installing the eDP cable
About this task
NOTE: The eDP cable installation procedure is applicable only for Latitude 5320 laptop and not for the 2-in-1 configuration.
The following image indicates the location of the eDP cable and provides a visual representation of the installation procedure.
Steps
Adhere the tape to securing the eDP cable to the display back cover.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the display assembly.
Removing and installing components
71
To Next Page
Loading...
