Dell Latitude 5320 - Removing the Infrared Camera

Steps
1. Insert the camera into the slot on the display back cover.
2. Connect the camera cable to the connector and adhere the adhesive tape above the camera connector.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the display assembly.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in after working inside your computer.
Removing the infrared camera
Prerequisites
NOTE:
The infrared camera removal procedure is applicable only for Latitude 5320 laptop and not for the 2-in-1
configuration.
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
5. Remove the display bezel.
6. Remove the display hinges.
7. Remove the display panel.
About this task
The following images indicate the location of the infrared camera and provide a visual representation of the removal procedure.
Removing and installing components
77