Installing the display back-cover
Prerequisites
NOTE: The display back-cover installation procedure is applicable only for Latitude 5320 laptop and not for the 2-in-1
configuration.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display back-cover and provides a visual representation of the installation
procedure.
Steps
Place the display back-cover on a flat surface and perform the following steps to install the display back cover.
Next steps
1. Install the eDP cable.
2. Install the camera.
3. Install the display panel.
4. Install the display hinges.
5. Install the display bezel.
6. Install the display assembly.
7. Install the battery.
8. Install the base cover.
9. Follow the procedure in after working inside your computer.
Removing and installing components
69
To Next Page
Loading...
