Installing the sensor board
About this task
The following images indicate the location of the sensor board and provide a visual representation of the removal procedure.
Steps
1. Align and place the sensor board on the display back cover.
2. Connect the display cable to the connector on the sensor board and close the latch.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the battery.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
LED board
Removing the LED board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
Removing and installing components
73
To Next Page
Loading...
