Steps
1. Insert the infrared camera into the slot on the display back cover.
2. Connect the infrared camera cable to the connector and adhere the adhesive tape above the camera connector.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the display assembly.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in after working inside your computer.
Smart card reader
Removing the smart card reader (optional)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the speakers.
About this task
NOTE:
For models with smart card reader configuration, the smart card reader is preinstalled in the replacement palm-rest
assembly.
The following images indicate the location of the smart card reader and provide a visual representation of the removal
procedure.
Removing and installing components
79
To Next Page
Loading...
