Steps
1. Place the display assembly on a clean and flat surface.
2. Align and place the palm-rest and keyboard assembly on the display assembly.
3. Using the alignment posts, close the display hinges.
4. Replace the two screws (M2.5x4) that secure the left-display hinge to the system board.
5. Replace the two screws (M2.5x4) that secure the right-display hinge to the system board.
6. Route the IR camera cable underneath the fan.
7. Connect the IR camera cable to its connector on the system board.
52
Removing and installing components
To Next Page
Loading...
