Steps
1. Connect the display cable to the connector and close the latch.
2. Adhere the adhesive strip to secure the display cable connector.
3. Insert the display panel tabs into the slots on the display cover.
4. Replace the two (M2x2.5) screws that secure the display panel to the display assembly.
Next steps
1. Install the display hinges.
2. Install the display bezel.
3. Install the display assembly.
4. Install the battery.
5. Install the base cover.
6. Follow the procedure in after working inside your computer.
Removing and installing components
65
To Next Page
Loading...
