Steps
1. Replace the three (M2x2) screws to secure the keyboard to the keyboard bracket.
2. Flip the keyboard assembly and align it to its slot on the palm-rest.
3. Press down on the lattice at the snap points, in order to secure the keyboard assembly to the palm-rest.
4. Replace the sixteen (M2x2) screws that secure the keyboard assembly to the palm-rest.
5. Connect the keyboard cable and keyboard backlit cable to its connectors.
Next steps
1. Install the display assembly.
2. Install the speakers.
3. Install the smart card reader (optional).
4. Install the power button with fingerprint reader.
5. Install the system board.
6. Install the heat sink.
7. Install the fan.
8. Install the battery.
9. Install the M.2 2280 SSD card or M.2 2230 SSD card.
10. Install the WWAN card (optional).
11. Install the WLAN card.
86
Removing and installing components
To Next Page
Loading...
