Installing the keyboard
1.
NOTE:
The keyboard has multiple snap points on the lattice side which must be pushed down firmly at the snap points
in order to secure and fit it to the replacement keyboard.
Align the keyboard to the keyboard support plate [1] and replace the two (M2x2) screws [2].
2. Place the keyboard assembly in the palmrest [1] and secure it with the 17 (M1.6x2) screws [2].
NOTE:
This image shows disassembly of a carbon fiber variant, an Aluminum variant of this model has 21 M1.6x2 screws
securing the keyboard assembly to palmrest. assembly.
Removing and installing components 87
To Next Page
Loading...
