4. Replace the foil from the top and bottom side of the CPU-shielding cover.
5. Replace the tape and cover the orange WWAN-antenna cable(AUX3) at the bottom side of the CPU-shielding cover.
Next steps
1. Install the base cover.
2. Install the SIM card.
3. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the base cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
NOTE:
The display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is removed
from the chassis. If any components on the display assembly are malfunctioning and must be replaced, replace the entire
touch-display assembly.
32 Removing and installing components
To Next Page
Loading...
