About this task
The following images indicate the location of the right speaker and provide a visual representation of the removal procedure.
Steps
1. Remove the single (M2x2.5) screw from the P-sensor bracket and remove the P-sensor bracket from the computer.
2. Remove the single (M2x2.5) screw from the WLAN bracket and remove the WLAN bracket from the computer.
3. Disconnect the speaker cable from the connector on the system board.
4. Disconnect the green P-sensor cable, gray P-sensor cable, and the WLAN antenna cables from their connectors on the
system board.
5. Remove the speaker, green P-sensor cable, gray P-sensor cable, and the WLAN antenna cables from the routing guides on
the system board and the right speaker.
6. Remove the single (M2x2.5) screw that secures the speaker to the palm-rest and keyboard assembly and remove the right
speaker from the computer.
Installing the right speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the right speaker and provide a visual representation of the installation procedure.
Removing and installing components
39
To Next Page
Loading...
