Steps
1. Align and place the right speaker in the slot on the palm-rest and keyboard assembly.
2. Replace the single (M2x2.5) screw to secure the right speaker to the palm-rest and keyboard assembly.
3. Route the speaker, green P-sensor cable, gray P-sensor cable, and the WLAN antenna cables through the routing guides on
the system board.
4. Connect the speaker, green P-sensor cable, gray P-sensor cable, and the WLAN antenna cables to their connectors on the
system board.
5. Place the P-sensor bracket on the system board and replace the single (M2x2.5) screw to secure it in place.
6. Place the WLAN bracket on the system board and replace the single (M2x2.5) screw to secure it in place.
7. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the battery.
2. Install the WWAN card.
3. Install the base cover.
4. Install the SIM card.
5. Follow the procedure in After working inside your computer.
40
Removing and installing components
To Next Page
Loading...
