Steps
1. Align and place the speakers in the slot on the palm-rest and keyboard assembly.
2. Replace the single (M2x2.5) screw to secure the speakers to the palm-rest and keyboard assembly.
3. Route the orange WWAN-antenna cable(AUX3) through the routing guides on the system board.
4. Adhere the adhesive tape to secure the orange WWAN-antenna cable to the palm-rest and keyboard assembly.
5. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the battery.
2. Install the WWAN card.
3. Install the base cover.
4. Install the SIM card.
5. Follow the procedure in After working inside your computer.
Removing the right speaker
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the base cover.
4. Remove the WLAN card.
5. Remove the battery.
38
Removing and installing components
To Next Page
Loading...
