Table 7. System setup options—Storage menu
Storage
SATA Operation Configures operating mode of the integrated SATA hard drive controller.
Default: RAID On. SATA is configured to support RAID (Intel Rapid Restore
Technology).
Storage Interface
Port Enablement Enables the selected onboard drives.
● SATA-4
Default: ON
● M.2 PCIe SSD-0
Default: ON
● M.2 PCIe SSD-1
Default: ON
Drive Information Displays the information of various onboard drives.
Enable SMART Reporting Enables or disables Self-Monitoring, Analysis, and Reporting Technology
(SMART).
Default: OFF
Table 8. System setup options—Display menu
Display
Display Brightness
Brightness on battery power Sets the screen brightness when the computer is running on battery power.
Default: 50
Brightness on AC power Sets the screen brightness when the computer is running on AC power.
Default: 100
Touch Screen Enables or disables the touch screen for the OS.
NOTE: The touch screen will always work in the BIOS setup irrespective of
this setting.
Full Screen Logo Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
Table 9. System setup options—Connection menu
Connection
Wireless Device Enable Enable or disable internal WLAN/Bluetooth devices.
By default, WLAN is selected.
By default, Bluetooth is selected.
Enable UEFI Network Stack
Enable UEFI Network Stack When enabled, UEFI networking protocols are installed and available, allowing
pre-OS and early OS networking features to use any enabled NICs. This may be
used without PXE turned on.
Default: ON
Wireless Radio Control
BIOS setup 61
To Next Page
Loading...
