Managing Images and Files 331
Data Type...................................... Code
Destination Filename........................... image
Management access will be blocked for the duration of the
transfer
Are you sure you want to start? (y/n)y
5
Activate the new image so that it becomes the active image after the
switch resets.
Use either the
active
or
backup
keyword, depending on which file type you
selected for replacement in step 4.
console#boot system active
Activating image active..
6
View information about the current image.
console#show bootvar
Image Descriptions
image1 :
image2 :
Images currently available on Flash
7
Copy the running configuration to the startup configuration to save the
current configuration to NVRAM.
console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during
this time.
Are you sure you want to save? (y/n)y
Configuration Saved!
8
Reset the switch to boot the system with the new image.
------- ------------ ------------ --------------- --------------
unit image1 image2 current-active next-active
------- ------------ ------------ --------------- --------------
1 4.1.0.7 5.0.0.8 image1 image2
To Next Page
Loading...
