Dell PowerEdge R860 - Page 107

Figure 67. Configuration 15: 24 x 2.5-inch (NVMe)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 83. 24 x 2.5-inch (NVMe)
Order From To
1 SL1_CPU2_PA1 (signal connector on system board) and
SL12_CPU4_PA1 (signal connector on PEM)
DST_PB2 and DST_PA1 (backplane
signal connector)
2 SL2_CPU2_PB1 (signal connector on system board) and
SL13_CPU4_PB1 (signal connector on PEM)
DST_PA3 and DST_PB1 (backplane
signal connector)
3 SL3_CPU2_PA2 (signal connector on system board) and
SL14_CPU4_PA2 (signal connector on PEM)
DST_PB3 and DST_PA2 (backplane
signal connector)
4 SL4_CPU1_PA3 (signal connector on system board) and
SL15_CPU3_PA3 (signal connector on PEM)
DST_PA4 and DST_PB5 (backplane
signal connector)
5 SL5_CPU1_PB3 (signal connector on system board) and
SL16_CPU3_PB3 (signal connector on PEM)
DST_PB4 and DST_PA6 (backplane
signal connector)
6 SL6_CPU1_PA4 (signal connector on system board) and
SL17_CPU3_PA4 (signal connector on PEM)
DST_PB5 and DST_PB6 (backplane
signal connector)
7 SIG_PWR_1 (system board power connector) BP _PWR_1 (backplane power
connector)
8 SIG_PWR_2 (system board power connector) BP _PWR2 (backplane power connector)
Installing and removing system components 107