Next steps
1. Install the power interposer board.
2. Install the system board. For more information, see the Installing system board section.
3. Connect the power cables to the system board and the hard-drive backplane.
4. If applicable, install the cooling fan assembly.
5. Install the cooling shroud.
6. Install the PCIe card holders.
7. Install the power supply module(s) in their original locations.
8. Follow the procedure listed in the After working inside your system section.
Figure 115. Installing the power distribution board
1. screws (6) 2. power distribution board
Related Links
Safety instructions
After working inside your system
Removing the power distribution board
Installing the power interposer board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Follow the safety guidelines listed in the safety instructions section.
199
To Next Page
Loading...
