Replace the system board
C
omplete the following procedure to replace the system board.
This FRU is not hot-swappable, and requires a system shutdown to replace.
After a system board replacement, user-configured iDRAC settings and users are reset. Those settings must be reconfigured
manually.
CAUTION:
Do not move the TPM from the old system board to the new system board. A new TPM is included
with the replacement system board.
Topics:
• V
erify the status of the system board
• Shut down and disconnect the system
• Remove a power supply
• Extend the system from the cabinet
• Remove the system cover
• Removing the air shroud
• Remove the cooling fan assembly
• Remove expansion card risers
• Remove the integrated storage controller card
• Remove the memory module
• Remove processor and heat sink module
• Remove the system board
• Install the system board
• Install a processor and heat sink module
• Install the memory module
• Install the integrated storage controller card
• Install expansion card riser 1
• Install expansion card riser 2
• Install expansion card riser 3
• Install the cooling fan assembly
• Installing the air shroud
• Install the system cover
• Install the power supply unit
• Slide the system into the cabinet
• Reconnect and power on the system
• Restoring the Service Tag by using the Easy Restore feature
• Enter the system Service Tag by using System Setup
• Import server profile
• Upgrade the identity module firmware
• Bring up the existing file system
• Restore the HA configuration
Verify the status of the system board
Prerequisites
Establish a connection to the system as described in Establish a serial management connection to the PowerProtect system on
page 14.
13
Replace the system board 105
To Next Page
Loading...
