For more information, see h
ttps://technet.microsoft.com/en-us/library/cc753140.aspx.
The TPM Status changes to Enabled, Activated.
Initializing the TPM 2.0 for TXT users
Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On.
4. Save the settings.
5. Restart your system.
6. Enter System Setup again.
7. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
8. Select the TPM Advanced Settings option.
9. From the TPM2 Algorithm Selection option, select SHA256, then go back to System Security Settings screen.
10. On the System Security Settings screen, from the Intel TXT option, select On.
11. Save the settings.
12. Restart your system.
Restore the HA configuration
Bring the HA configuration back online after completing the maintenance activity.
About this task
For single node systems, skip these steps.
Steps
1. Run the ha online command on the node where the maintenance was performed to bring the HA configuration back
online.
# h
a online
The operation will reboot this node.
Do you want to proceed? (yes|no) [no]: yes
Broadcast message from root (Wed Jul 22 17:03:32 2020):
The system is going down for reboot NOW!
This node is changed to online state.
Node is going down for reboot.
2. Run the ha status command to verify that the HA pair is back online, and can failover.
HA System Name: datadomain-ha3a.emc.com
H
A System Status: highly available
Node Name Node ID Role HA State
-------------------------- --------- --------- --------
datadomain-ha3a-p0.emc.com 0 standby online
datadomain-ha3a-p1.emc.com 1 active online
-------------------------- --------- --------- --------
3. Optionally run the ha failover command on the current active node to fail the system back to the original active node.
Replace the Trusted Platform Module (TPM) 83
To Next Page
Loading...
