Dell PowerProtect DD6900 - Replace the Trusted Platform Module (TPM)

Replace the Trusted Platform Module (TPM)
T
he PowerProtect system uses a TPM to secure the system.
Complete the following procedure to replace the TPM.
This FRU is not hot-swappable, and requires a system shutdown to replace.
Topics:
• Verify the status of the TPM
• Shut down and disconnect the system
• Extend the system from the cabinet
• Remove the system cover
• Locate the TPM
• Upgrading the Trusted Platform Module
• Install the system cover
• Slide the system into the cabinet
• Reconnect and power on the system
• Initializing TPM for BitLocker users
• Initializing the TPM 2.0 for TXT users
• Restore the HA configuration
Verify the status of the TPM
Prerequisites
Establish a connection to the system as described in Establish a serial management connection to the PowerProtect system on
page 14.
About this task
Complete the following steps to verify the TPM replacement.
Steps
Run the system show all command, and look for the line indicating the TPM. If it is not present, the TPM requires
replacement:
TPM device: Nuvoton chip for Rest of World
S
hut down and disconnect the system
Prerequisites
Establish a connection to the system as described in Establish a serial management connection to the PowerProtect system on
page 14.
About this task
Complete the following steps to shut down and disconnect the system.
10
Replace the Trusted Platform Module (TPM) 77