Figure 13. Removing expansion card riser 2
R
emove the network daughter card
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system
board.
2. Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3. Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
Figure 14. Removing the network daughter card
I
nstall the network daughter card
Steps
1. Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
Replace the Network Daughter Card 39
To Next Page
Loading...
